Datasheet4U Logo Datasheet4U.com

MAX14826 - IO-Link Device Transceiver

Description

The MAX14826 transceiver is suitable for IO-Link® devices and 24V binary sensors.

All specified IO-Link data rates are supported.

In IO-Link applications, the transceiver acts as the physical layer interface to a microcontroller running the data-link layer protocol.

Features

  • reverse-polarity, short-circuit, and ther.

📥 Download Datasheet

Datasheet preview – MAX14826

📁 Similar Datasheet

  • MAX1482 - Slew-Rate-Limited RS-485 Transceivers (Maxim)
  • MAX148 - +2.7V to +5.25V / Low-Power / 8-Channel / Serial 10-Bit ADCs (Maxim)
  • MAX14800 - High-Voltage Analog Switches (Maxim Integrated Products)
  • MAX14801 - High-Voltage Analog Switches (Maxim Integrated Products)
  • MAX14802 - High-Voltage Analog Switches (Maxim Integrated Products)
  • MAX14803 - High-Voltage Analog Switches (Maxim Integrated Products)
  • MAX14805 - High-Voltage Analog Switches (Maxim Integrated Products)
  • MAX14806 - High-Voltage Analog Switches (Maxim Integrated Products)
  • MAX1480B - Isolated RS-485/RS-422 Data Interface (Maxim Integrated Products)
  • MAX1480E - (MAX1480E / MAX1490E) Isolated RS-485/RS-422 (Maxim Integrated Products)
Other Datasheets by Maxim Integrated
  • MAX14820 - IO-Link Device Transceiver
  • MAX14821 - IO-Link Device Transceiver
  • MAX14824 - IO-Link Master Transceiver
  • MAX14827 - IO-Link Device Transceiver
  • MAX14827A - IO-Link Device Transceiver
  • MAX14803A - High-Voltage Analog Switches
  • MAX14808 - Octal Three-Level/Quad Five-Level High-Voltage 2A Digital Pulsers
  • MAX14809 - Octal Three-Level/Quad Five-Level High-Voltage 2A Digital Pulsers

Full PDF Text Transcription

Click to expand full text
MAX14826 IO-Link Device Transceiver General Description The MAX14826 transceiver is suitable for IO-Link® devices and 24V binary sensors. All specified IO-Link data rates are supported. In IO-Link applications, the transceiver acts as the physical layer interface to a microcontroller running the data-link layer protocol. Additional 24V digital inputs and outputs are provided. Two internal linear regulators generate common sensor and actuator power requirements: 5V and 3.3V. On-board C/Q and DO drivers are independentlyconfigurable for push-pull, high-side (PNP), or low-side (NPN) operation. The device detects the IO-Link C/Q wake-up condition and generates a wake-up signal on the active-low WU/THSD output.
Published: |